To build the ship from scratch (for example, on a planet), start by building a 'bootstrap projector' as mentioned earlier. You may also want to Refresh Blueprints and delete any additional copies of the ship that were added to the list, just to avoid confusion. Use Ctrl-B on the ship again, select the existing blueprint, and click on 'Replace With Clipboard'.However, make a note of exactly which hotkeys you used, as you may have to reassign them after building a new copy of the ship. Optional: If you want to add any hotkey assignments to toggle the repair projector On and Off from a seat, do this now.(The status may also warn that the projection is out of bounds, but this is okay.) With the projector block On, check that its status in the Terminal includes the word 'Complete!', then be sure to turn the projector Off.Write all these values down for later reference. Adjust the rotations and offsets until the projection aligns perfectly with the solid ship.('Show Only Buildable: On' may be helpful, but this is a matter of taste.) This is crucial, because otherwise the projector will clear its blueprint selection as soon as the projection is properly aligned. Set the projector to 'Keep Projection: On'.Set the repair projector to project that new blueprint.Create a blueprint of the ship with Ctrl-B.Once you are finished with your ship design and build:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |